Your present location:G-PAK PRODUCTS >> G-PAK14.1 >> Turning Inserts for Stainless Steel Finishing–SF Geometry

Features
• Smooth surface finish: Free cutting, excellent surface finish (up to Ra0.32) and minimal to no burrs.
• Low Cutting Forces: Sharp edge due to results in low cutting forces particularly for thin wall structures and extended shafts.
• Excellent Wear Resistance:An advanced PVD TiAlN coating over a very deformation-resistant carbide substrate.
• Excellent Chip Control:Good chip control and chip flows effectively away from the cutting zone.


Application
• Finish turning and boring primarily in stainless steel
• Suitable for stainless steel and Heat Resistance Super Alloy (HRSA)
• SF Geometry + GS3115 Grade : Superior wear resistance

 
CONTANT:
* Entered characters:0 Word
Less than or equal500Character
message man:
 
sex:
  Mr. Ms.
mail:
 
phone:
 
tel:
 
Verification code:
   
 
ADD:No. 69 Xinglong Road, Huli District, Xiamen
Factory Address:Xiamen Tongan Industrial Zone Set
E-mail:gesac@cxtc.com